Wireless > Wmm - Cisco Linksys WET610N Guia Del Usuario

Linksys WES610N/WET610N
WPA2
Network Name (SSID) The name of the network you selected is automatically
displayed
Security Mode
WPA2 Personal is automatically displayed
Encryption
WPA2 supports two encryption methods, TKIP and AES, with
dynamic encryption keys Select the encryption method, AES or TKIP or AES
Passphrase Enter the key shared by the bridge and wireless router or access
point It must have 8-63 characters
Click Refresh to update the on-screen information
After you have entered the security settings, click Connect
WEP
Network Name (SSID) The name of the network you selected is automatically
displayed
Security Mode WEP is automatically displayed
Encryption Select a level of WEP encryption, 40/64 bits (10 hex digits) or
104/128 bits (26 hex digits)
Key 1 Enter the WEP key of your network
Tx Key Key 1 is the transmit key used by the bridge
Authentication The default is Auto, which allows either Open system or Shared
key authentication to be used Select Open to use open system authentication;
the sender and recipient do not use a WEP key for authentication Select
Shared to use shared key authentication; the sender and recipient use a WEP
key for authentication
Click Refresh to update the on-screen information
After you have entered the security settings, click Connect
Wireless > WMM®
Configure the Wireless MultiMedia (WMM) settings WMM prioritizes packets
depending on their respective access mode (traffic type): Background, Best
Effort, Video, or Voice These settings should only be adjusted by an expert
administrator as incorrect settings can reduce wireless performance
NOTE
The settings on the WMM screen are designed for advanced users
only
Advanced Configuration
11