Trevi CR 410 Manual Del Usuario página 4

CR 410
INDEX
1. PLAY button
2. STOP button
3. F.FWD (Fast forward) button
4. REW (Rewind) button
5. RECORD button
6. Voice-activated system (VAS) switch
7. PAUSE button
8. SPEED switch
9. Built-in microphone
10.Record indicator
11.Earphone jack
12.External microphone jack
13.VOLUME control
14.Battery compartment ( on back panel )
15.3V DC power jack
16. Cassette compartment
OPERATION RECORDING
1. Open the cassette compartment.
2. Install a cassette with desired side facing
outward (visible through window).
3. Close the cassette compartment.
4. Set the VAS switch to OFF (for normal
recording) or ON (to activate the voice
activated system).
5. Press the RECORD button. The PLAY
button will automatically engage. The
Record indicator will alight.
6. Place the recorder close to the sound
source.
7. Press the STOP button to stop recording.
NOTE
1. The first few sounds that activate the unit
may not be recorded .For best results, say
a few introductory words before you
begin dictation.
2. Variation in voice level will not
temporarily stop the unit (two-to-six
seconds of silence is required).
3. Built-in record level control automatically
All manuals and user guides at all-guides.com
NOTEMANAGER
p.4
sets the recording input level.
CONTROLS TAPE SPEED
1. Nor (normal) tape speed: Compatible with
most single-speed micro cassettes.
2. Low tape speed: for longer recording,
allows you to record up to three hours on
a 90-minute (C-90) cassette.
NOTE: Do not change the tape speed while
recording.
PAUSE CONTROL
Slide the PAUSE switch up to suspend
function in PLAY, RECORD, FAST FORWARD
or REWIND mode. Slide the switch down to
resume operation.
FAST FORWARD AND REWIND
To rapidly advance or rewind the tape, press
the F.FWD or REW button. To stop the tape at
the desired position or once the tape has
ended press STOP button again.
SET -UP
Install two AA batteries (not included) into
the battery compartment, matching the
polarity as indicated inside the chamber.
VOLUME/VAS SENS CONTROL
When the unit is in playback mode, this
control (13) adjusts the playback volume
level.
When the unit is in record mode, this control
adjust the microphone sensitivity. At
maximum, a soft sound can turn on the
recorder. At minimum, a louder sound is
required.
VOICE ACTIVATED SYSTEM (VAS)
1. Set VAS switch to ON; when dictation
pauses for two to six seconds, recording
will stop temporarily. When dictation
resumes, recording will continue.
2. Set VAS switch to OFF; recording will
continue until the STOP/EJECT button is
ENGLISH