Siemens LF 157 GA 70 Instrucciones De Uso Y De Montaje página 18

If you encounter a problem
If an or [ appears in the display:
See „Filters and maintenance" Section.
If is not possible to operate the extractor
hood:
Disconnect the extractor hood from the
mains electricity supply by pulling out the
plug or switching it off at the main fuse box.
Wait for approx. 1 minute and then switch it
on again.
If you have any questions or if a fault occurs,
please call Customer Service.
(See list of
representatives).
When you call, please quote the following:
AB - Nr .:
Enter the relevant numbers into the box
above. The AB - Nr . (product no.) and FD
(production date) are shown on the
nameplate which can be seen inside the
extractor hood after the filter frame has been
detached.
The manufacturer of the extractor hoods
accepts no liability for complaints which can
be attributed to the design and layout of the
pipework.
Important information
Old appliances are not worthless rubbish.
Valuable raw materials can be reclaimed by
recycling old appliances. Before disposing
of your old appliance, render it unusable.
You received your new appliance in a
protective shipping carton. All p ackaging
materials are environmentally friendly and
recyclable. Please contribute to a better
environment by disposing of packaging
materials in an environmentally-friendly
manner .
Please ask your dealer or inquire at your
local authority about current means of
disposal.
All manuals and user guides at all-guides.com
Customer Service
FD
Inst allation Instructions
The extractor hood can be used in exhaust
air or circulating air mode.
Always mount the extractor hood over the
centre of the hob.
Minimum distance between electric hob and
bottom edge of extractor hood: 550 mm,
AThe extractor hood must not be inst
over a solid fuel cooker - a potential fire
hazard (e.g. flying sparks) -unless the cooker
features a closed, non-removable cover
and all national regulations are observed.
The smaller the gap between the extractor
hood and hotplates, the greater the
likelihood that droplets will form on the
underside of the extractor hood.
Additional information concerning gas
cookers:
When installing gas hotplates, comply with
the relevant national statutory regulations
(e.g. in Germany: T echnische Regeln Gas-
installation TRGI).
Always comply with the currently valid
regulations and installation instructions
supplied by the gas appliance manufacturer
Only one side of the extractor hood may be
installed next to a high-sided unit or high
wall. Gap at least 50 mm.
Minimum distance on gas hotplates
between the upper edge of the trivet
and lower edge of the extractor
hood: 650 mm
en
alled
.