Panasonic TY-SP65P10WK Instrucciones De Instalación página 4

Installation
Mount A bracket
Rear of Plasma Display
Preparing the ends of the
speaker cables
1. Press down on the lever.
2. Insert the
cable.
3. Release the
lever.
Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households)
This symbol on the products and/or accompanying documents means that used electrical and electronic products
should not be mixed with general household waste.
For proper treatment, recovery and recycling, please take these products to designated collection points, where
they will be accepted on a free of charge basis. Alternatively, in some countries you may be able to return your
products to your local retailer upon the purchase of an equivalent new product.
Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on
human health and the environment which could otherwise arise from inappropriate waste handling. Please contact
your local authority for further details of your nearest designated collection point.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information.
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal.
4
Mount B
bracket
Bracket mounting
screws
Remove while
twisting
1. Push down the lever.
2. Insert the
3. Return the lever to its
normal position.
4. Fasten the A and B
brackets
• Catch the B bracket claws in the A brackets
(plasma display side).
Fasten the A and B brackets with bracket
mounting screws.
• Adjust display and speaker height when
fastening the A and B brackets.
5. Connect the speaker
cables.
• After preparing the ends of the speaker
cables for the right speaker, connect them as
shown in the illustration.
• Connect the speaker cables for the left
speaker in the same way.
• The red cable is for the (+) polarity and the
black cable is for the (-) polarity. Do not
connect the cables to the wrong polarities.
cable.