LumaPro Dualbrite 2LBN5 Manual De Instrucciones Y Partes página 4

NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming
the sensor down will reduce coverage distance.
The detector is less sensitive to motion directly towards it.
Motion
Sensor
D Z ™
ual one
Least Sensitive
3. Loosen the clamp screw in the
sensor ball joint and gently ro-
tate the sensor.
4. Walk through the coverage
area noting where you are
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cover-
age area. Keep the sensor at
least 1" (2.5 cm) away from
the lamps.
All manuals and user guides at all-guides.com
1. Secure the sensor head's
Motion
2. Adjust the RANGE as
3. Set the amount of TIME you want the lights to stay
D Z ™
ual one
Most Sensitive
4. Set the D
Clamp
Screw
Ball
Joint
at a combustible surface within 3 ft. (1 m).
Aim Sensor
Down for Short
Coverage
-4-
Final Settings
aim by tightening the clamp
screw. Do not overtighten
the screw.
needed. RANGE set too
high may increase false
triggering.
on after motion is detected (1, 5, or 20 minutes).
B switch to the amount of time af-
®
ual rite
ter dusk you want the lights on at low level (Off, 3,
6 Hrs., Dusk-to-Dawn). Selecting OFF defeats only
the dim mode. If motion is sensed, the light turns
on full bright for the ON-TIME (1, 5, or 20 minutes)
then returns to dim mode.
WARNING: Risk of fire. Do not aim the bulbs
Aim Sensor Higher
for Long Coverage
598-1010-05