Troubleshooting; Charger Indicator - WorkPro W159007A Instrucciones Originales De Operaciones

9. Troubleshooting

Danger! Risk of injury!
Unprofessional repairs may mean that your unit will no longer operate safely. This endangers you Malfunctions are
often caused by minor faults. You can easily remedy most of these yourself. Please consult the following table
before contacting the vendor. You will save yourself a lot of trouble and possibly money too.
Error/Fault
Device does not work

10. Charger Indicator

Indicator Status
Red LED Green LED
ON OFF
Quick
OFF Blink
(2Hz)
Slow
OFF Blink
(1Hz)
OFF ON
Quick
Blink OFF
(2Hz)
Slow
Blink OFF
(1Hz)
GB
Cause
Battery not slotted in correctly?
Battery pack discharged?
Battery pack defective?
Is the device defective?
Explanations and Actions
Ready for use
The charger is connected to the mains and is ready for use; there is no battery
pack in the charger
Low-current safety charging
As the battery pack voltage is under 15V,the charger is in gentle charging
mode,the charging current is below 0.5A.This can maximum the life of the
battery.
High-current charging
As the battery pack voltage is above 15V,the charger is in quick charge
mode,the charging current is at 2.3-2.4A.
Important! The actual charging times may vary slightly from the stated charging
times depending on the existing battery charge.
The battery is charged and ready to use.
The battery is fully charged and ready to use.
Action:
Take the battery pack out of the charger. Disconnect the charger from the
mains supply.
Fault
Charging is no longer possible. The battery pack maybe defective.
Action:
Never charge a defective battery pack.Take the battery pack out of the charger.
Temperature fault
The battery pack is too hot (e.g. due to direct sunshine/prolonged use) or too
cold (below 40° F).
Action:
Remove the battery pack and keep it at room temperature (approx. 68° F) for
3 Hours .
11
Remedy
Slot battery into place
Charging the battery pack
Contact your local vendor.