Battery Operation; Adjusting The Volume - Akai AB-50 Manual De Instrucciones

Connecting AC Power
The unit is designed to operate from mains supply of AC 230V~50Hz. Connect the small end of AC cord to
the socket at the back of the main unit and insert the plug of AC cord into standard AC wall outlet.
When the unit is intended for being unused for a long period of the time. Please slide the FUNCTION
switch to OFF position to turn off the unit and unplug the power cord from the AC wall outlet.

Battery Operation

Before installing batteries (not included), ensure
that the unit is disconnected from the mains
supply.
Remove the battery compartment cover on the
bottom of the unit by carefully pushing the
batteries cover. The battery cover can then be
lifted away.
Fit 6 x 1 .5V C-size batteries (not included),
referring to the polarity markings inside the
battery compartment. Never mix old and new
batteries. Finally, replace the cover.
For battery operation, switch off the mains
supply and remove the cable from the power
socket, battery operation will be selected
automatically.
Caution:
There is a danger of explosion if batteries are replaced incorrectly.
Replace batteries with the same type and same brand only.
If the unit will not be used for a long period of the time, slide the FUNCTION switch to OFF
position and remove all batteries from the main unit.
Using Headphones (not included)
If you would like to listen to your music privately through the use of headphones, you may do so in one
step. Simply plug your headphones into the phones socket, located on top the unit. Compatible
headphones have a 3.5mm diameter stereo plug and an impedance of 8-32 Ohms. When your
headphones are connected, the stereo speakers are automatically disconnected.
Establish a safe sound level
Over time your hearing will adapt to continuous loud sounds and will give the impression that the volume
has in fact been reduced. What seems normal to you may in fact be harmful. To guard against this before
your hearing adapts, set the volume to a low level.
Slowly increase the level until you can hear comfortably and clearly and without distortion. Damage to your
hearing is accumulative and is irreversible. Any ringing or discomfort in the ears indicates that the volume
is too loud. Once you have established a comfortable listening level, do not increase the sound level.

Adjusting the Volume

Turn the VOLUME Control knob to increase / decrease the volume sound.
Adjusting the rod antenna
The aerial should be extended to ensure good reception in both FM radio modes. It may be necessary to
adjust the position of the unit and /or aerial position to achieve the best signal reception.
All manuals and user guides at all-guides.com
POWER CONNECTION & OPERATION
12