Battery Replacement - König Health Care HC-DT10 Manual De Uso

All manuals and user guides at all-guides.com
How to use:
1. Before using, please disinfect the probe with alcohol first.
. Press the on/off button, Bi sound will be heard and display „88.88°C for about  seconds.
3. After that, the thermometer will display the last temperature memory record for about  seconds,
and then display L °C (Lo°C), signal °C flashing, that means the thermometer is waiting for use. If
the temperature measured is below or above the display range the thermometer will display either
the „L" or the „H" symbol. The display range for this thermometer is 3.00°C to 43.00°C.
4. Use the thermometer to measure body temperature. The value of temperature displayed will arise
gradually and °C is flashing.
5. The measurement process usually takes about 1 min (in oral). After measurement, °C will stop
flashing and the alarm signal will sound for about 5 seconds, at the same time, the thermometer
will display the user's body temperature.
6. This thermometer can automatically shut off within 10 minutes after measurement. It is
recommended to turn off the power manually right after measurement in order to save energy.
Take temperature:
When you measure your body temperature, please remain to measure at the same place for some
time.
1. To take temperature under tongue, before measurement please close your mouth for 5 minutes,
then insert the sensor part under the tongue, keeping nestled and close your mouth. LCD reading
is final reading.
. To take temperature in the armpit, before measurement please completely wipe the sweat there
away, then close the armpit for about 5 minutes and insert the sensor part against the center of
the armpit closely. Put both left and right waist intersection, making the thermometer in contact
with the user's body closely. Add 0.5 °C to LCD reading to obtain final reading.
3. To take temperature in the rectum, inserts the sensor part into anus gently. Minus 0.5 °C to LCD
reading to obtain final reading.
Cautions:
1. Do not bend or drop the thermometer.
. Please disinfect the probe with alcohol, do not boil the probe.
3. Do not put the thermometer in contact with chemical reagent or diluents.
4. Avoid exposing the thermometer under direct sunlight.
5. Don't disassemble the thermometer except replacing the battery.
6. This thermometer has already been calibrated while making. If use according to the operation
instruction, does not need to calibrate again.

Battery replacement:

1. The battery needs to be replaced by a new battery when the LCD displays
. Please open the battery cover, take out the old battery with a toothpick.
3. Place a new 1.5V button battery (LR/SR-41).
4. Replace the battery cover.
: Degree of protection against electric shock is Type B applied part.
: The disposal of battery and device shall comply with the local environment requirements.
The device comply with the standard of IEC 60601-1:1998+ A1:1991+ A2:1995 and IEC60601-1-2:2001

or .