Humanscale M10 Instrucciones De Montaje página 5

Attach Arm To Base Stem
NOTE: Before adding each link, adjust the smart stop (A)
according to step 2. The links should be positioned so that
the monitors do not extend beyond the desk surface.
1
Insert the angled link into the mount until release
button locks in place.
2
Insert the dynamic link into the angled link until the
release button locks in place.
3
To remove links, press the release button (B) and lift
upward near the joint.
Attach Crossbar To Arm (Dual-Monitor Application Only)
If using dual monitors, attach the crossbar according to the
following steps. If using triple monitors, use the instructions
included with the triple crossbar. If using a single monitor,
continue to Step 5.
1
Attach crossbar (A) to crossbar link (B) using crossbar link
screws (C). Tighten with 4mm hex key until secure.
2
(Optional) Attach handle (D) to crossbar by using included
screws (E). Adjust the handle to desired height. Tighten
with 4mm hex key until secure.
WARNING: Risk of Injury - Do not allow crossbars to be
positioned so that the monitors extend beyond the work
surface which the mount is installed to at all times.
②
A
④
A
C
⑤
E
①
A
③
B
B
D
5