Velleman HQ Power MICW31 Manual Del Usuario página 2

4. Installation
• Install the device in a location where few people pass by and that is unreachable for unauthorised persons.
• Only use the included adaptor to connect the receiver to the power output.
• Install antenna A and B on the backside of the receiver.
• Use an audio cable to connect the receiver with another device (mixer, amplifier etc.). You have a balanced
output through an XLR output connector.
5. Use
• Make sure the power switch is set to "OFF".
• Insert the DC jack of the adaptor into the device and plug the adaptor into the mains outlet.
• Set the power switch to "ON". The device starts operating.
• Set the power switch to "OFF" to stop the device.
a. Receiver (front) (fig. 1)
1. Power switch
2. LED: lights when the power is ON
3. SET: fine-tune the frequency and reset it by hand
4. UP: next channel
5. DOWN: previous channel
6. LCD screen
7. Volume knob
8. Antenna A
9. Antenna B
b. Receiver (back) (fig. 2)
10. Balanced output
11. MIX output
12. Power input (17VDC)
c. Microphone (fig. 3)
1. Battery compartment (channel selector inside)
2. ON/OFF switch
3. Power LED
d. LCD screen
CH05 863.500M
00dB AF
DOWN to fine-tune the channel frequency. Make sure to match the channel on the microphone with the channel on
the receiver. To do so, open the battery compartment of the microphone and locate the blue channel selector. Use
the small flat screwdriver (incl.) to position the arrow on the correct channel (0 ~ F matches channel 1 ~ 16 on the
receiver). The Ψ symbol indicates the signal's direction. When the signal is weak for antenna A, it will automatically
switch to antenna be and vice versa. The signal status (within 00 ~ 40dB) will be displayed in the left bottom corner.
AF will indicate the audio frequency. To turn off the receiver, press POWER.
MICW31
All manuals and user guides at all-guides.com
After switching on the receiver, the channel will be displayed. This
AΨB
will be the last channel used before switching off. Use the UP or
DOWN button to select the desired channel (for the channel
frequencies, refer to the table below). Press SET and then UP or
2
Fig. 1
Fig. 2
Fig. 3
VELLEMAN