Replacing The Charcoal Filter; Replacing The Lamp; Environmental Concerns - Zanussi ZFT919Y Manual De Instrucciones

1
2
2. Slightly tilt the front of the filter downwards (2),
then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first two
steps in reverse order.
Repeat the steps for all filters if applicable.

REPLACING THE CHARCOAL FILTER

WARNING! The charcoal filter is non-
washable!
The time of saturation of the charcoal filter varies
depending on the type of cooking and the regularity
of cleaning the grease filter.
To replace the filter:
1. Remove the grease filters from the appliance.
Refer to "Cleaning the grease filter" in this chapter.

ENVIRONMENTAL CONCERNS

Recycle materials with the symbol
packaging in relevant containers to recycle it. Help
protect the environment and human health by
recycling waste of electrical and electronic
appliances. Do not dispose of appliances marked
24
2. press the tab (1) and slightly tilt the front of the
3. To install a new filter, perform the same steps in
In any case, it is necessary to replace the filters at
least every four months.
FILTER ALARM
To reset the alarm:
Touch the

REPLACING THE LAMP

This appliance is supplied with a LED lamp. This
part can be replaced by a technician only. In case
of any malfunction refer to "Service" in the "Safety
Instructions" chapter.
with the symbol
. Put the
Return the product to your local recycling facility or
contact your municipal office.
filter.
1 1
reverse order.
Refer to activating and deactivating
the filter alarm in daily use chapter.
Refer to cleaning the grease filter in
this chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter (depends
on filter type).
for 3 seconds.
with the household waste.