(En) Getting Started - Behringer XD8USB Manual Del Usuario

30
XD8USB
XD8USB Getting started

(EN) Getting started

1. Assemble the drum kit as shown in the
assembly instructions, and tighten
all connections.
2. Connect the cables to the drum pads,
cymbals and foot pedals, as shown in the
hook-up diagram.
3. Connect headphones or make connections to
any external sound equipment such as an
external amplifier, or active speaker. See the
hook-up diagram for some ideas.
Phones
DC IN
Power
Adapter
4. Connect the power supply adapter to the local
mains supply. This universal adapter can accept
mains voltages from 100 VAC to 240 VAC.
Connect the DC output to the drum module.
5. Do not turn on the drum module until all
connections have been made.
6. Turn down the VOLUME control on the drum
module, and turn on the POWER switch.
7. If you are using external sound equipment,
turn it on after the drum module. At the end of
the session, turn any external sound equipment
off first.
PLAYING
Play the kit and adjust the volume in your headphones
or external sound system to a safe listening level.
Each drum head or cymbal can give different sounds
depending on where it is hit:
Crash and Ride
Snare
Rim
Toms
Hi-Hat
Phones
Bow Shot with:
Pedal Open
Pedal Closed
Pedal Only: Press down for "Chick"
Kick
Kick
KIT
1. Press KIT and the current kit number will
be displayed.
2. Press + or – to select from 10 preset kits, or 5
user kits 11 to 15. Play each kit to hear how
it sounds.
Bow
3. If required, press VOLUME and adjust the kit
volume using + or –.
Head
4. To save this as a new kit, press SAVE/REC and
press + or – to choose from 11 to 15.
Head
5. Press SAVE/REC again to save the new user kit.
Bow
PATTERN
There are 40 different patterns available for practice.
Pattern 41 is reserved for recording your own playing
while in recoding mode.
1. Press START/STOP to start the pattern.
2. Press PAT to display the current
pattern number.
3. Press + or – to select a pattern.