Operation; Before Vacuuming; Adjusting The Suction Power - Royal Dirt Devil M7110 Manual De Instrucciones

All manuals and user guides at all-guides.com
02_M7110_gb.book Seite 27 Freitag, 10. Oktober 2008 10:17 10

3 Operation

3 Operation

3.1 Before vacuuming

3.2 Adjusting the suction
power
8
9
WARNING:
Danger of injury! A damaged appliance must never be
used. Check the cylinder vacuum cleaner and the power
cord before each use.
ATTENTION:
Only use the cylinder vacuum cleaner with all filters
intact, in dry condition and correctly placed. Make sure
that the openings of the cylinder vacuum cleaner are not
clogged.or obstructed. Otherwise the cylinder vacuum
cleaner might be damaged.
ATTENTION:
Check the requirements of your floorings before using
the cylinder vacuum
recommendations of the flooring manufacturers.
NOTE:
Your cylinder vacuum cleaner is equipped with a safety
switch to prevent overheating. It automatically cuts off
the power supply if the motor is overheated. In this case
switch off the cylinder vacuum cleaner with the on/off
switch and pull the plug from the mains socket. Remove
the cause of the overheating. Wait for about 45 minutes.
After it has cooled off, you may use the cylinder vacuum
cleaner again.
You can adjust the suction power to suit the type of floor
being cleaned.
1. To do this, slide the suction power control (Fig. 8) from
low (e.g. for textiles and upholstered furniture) to high
(e.g. for deep-pile carpets).
2. Adjust the suction power during vacuuming to suit your
needs.
NOTE:
With the bypass vent (Fig. 9/1) you can quickly reduce
the suction power if less power is needed (e.g. for
vacuuming curtains or drapes), or to release objects
accidentally sucked in.
cleaner. Follow the
27