Remote Control Introduction - THERMEx PUREMEX I Manual De Instrucciones

64 THERMEX PUREMEx I

Remote control introduction

REMOTE CONTROL INTRODUCTION
Power button:
Turn the fan on and off
Max mode:
Maximum power
Strong airflow
UV sterilization
Sterilization function
The device can be switched on and off by pressing the "ON &
OFF" button.
Press the"strong wind mode"button on the remote control.
The display will show H and the wind strength will increase.
Press again to exit strong wind mode.
(You can also exit the current mode by pressing the"+-"E xit button.)
Press this key to turn on the UV germicidal lamp,the display shows U.
When operating the after turning off the screen,first activate the
display to show U,and the gear position will be shown after � seconds.
Press again to turn off the UV germicidal lamp.
Press the "Oscillation" button on the remote control to switch
on the oscillating function. This fan can swing �� ° left and
right.
Press this button again to end the shaking process.
Press the"+"button on the remote control to increase the air
volume.
Press the"-"button to decrease the air volume.
There are �-speed settings.
Press the timer button on the remote control to set �to� hours.
After the timer function is set,other functions can be used
normally.
When the device is turned off,the timing setting is also canceled.
M 740212010204022021
Swing:
start and stop swing
Increase Airflow
Decrease Airflow
� speed levels to
choose from
Sleep Timer
�to� hours of tomed
shutdown