10.1 Clean The Machine; 10.2 Lubricate The Blade; Store The Machine; Troubleshooting - GreenWorks HTE321 Manual Del Operador

EN
Remove the battery pack from the machine before
maintenance.

10.1 CLEAN THE MACHINE

Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.

10.2 LUBRICATE THE BLADE

To increase the efficiency and life of the blades,
lubricate them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to
remove more dirt.
• Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
11

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
4. Store the machine in a cool and dry location.
12

TROUBLESHOOTING

Problem
The motor does
not start when
you pull the trig-
ger.
WARNING
WARNING
NOTE
NOTE
Possible cause Solution
Make sure that
The battery pack
you tighlty install
is not installed
the battery pack
tightly.
in the machine.
The battery pack Charge the bat-
is out of power. tery pack.
English
Problem
The machine
smokes during
operation.
The motor is on,
blades do not
move.
There is too
much noise
and/or vibration
during operation.
13

TECHNICAL DATA

Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
14

LIMITED WARRANTY

YEAR/ANS/AÑOS
TOOL WARRANTY
GARANTIE DE
L'OUTIL
HERRAMIENTA
®
Greenworks hereby warranties this product, to the
original purchaser with proof of purchase, for a period of
four (4) years against defects in materials, parts or
8
Possible cause Solution
1. Immediately
stop the ma-
chine.
The machine 2. Remove the
has damage. battery pack.
3. Speak to
service cen-
ter.
Do not use the
The machine machine and
has damage. speak to service
center.
Remove battery
The blades are pack then clear
blocked. blockage from
the blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loosen.
damage.
4. Check and
tighten loose
parts.
Do not use the
The parts have machine and
damage. speak to service
center.
48 V
3200(±10%) SPM
24'' (610 mm)
3/4'' (18 mm)
5.7 lbs. (2.6 kg)