Important Safeguards - KRATOS 69K-783 Manual De Funcionamiento, Instalación Y Mantenimiento

IMPORTANT SAFEGUARDS

Before the appliance is used, it must be properly positioned and installed as described in this manual,
so read the manual carefully. We strongly recommend that you have a qualified service technician
install your new machine. The warranty may be affected or voided by an incorrect installation. To
reduce the risk of fire or injury when using the appliance, follow basic precautions, including the
following:
CAUTION
Never clean appliance parts with flammable fluids. Do not store or use gasoline or other flammable vapors and

liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.
Disconnect gas line before cleaning or servicing. Failure to do so can result in fire or injury.

Do not leave appliance unattended with main gas valve open.

This unit is designed to be used with legs. Do not use without legs. Use of this equipment without legs can cause the unit

to overheat and cause a fire.
If unit is placed on a moveable table or base, it requires a quick disconnect hose and restraining cable for safe operation

Before using this equipment, it must be cleaned thoroughly. Clean all surfaces before use.

Failure to clean surfaces before using the unit could cause food contamination and excessive smoking.

Do not spray controls or outside of unit with liquids or cleaning agents.

DO NOT use an open flame to check for leaks. Check all gas piping for leaks with a soap and water solution before

operating unit.
This appliance must be properly installed and located in accordance with the Installation Instructions before it is used.

It is important for the appliance to be level for proper operation. You may need to make adjustments to level it.

Remove the packing materials and clean the appliance before using.

Do not use this apparatus for other than its intended purpose.

Smoke appearing on initial use of the appliance is normal. This is as a result of the rust preventing coating burning off.

Allow the unit to 'burn in' for at least 30 minutes before the first use.
Page 5