Preparation; Charging; Turning The Power On/Off; Connecting A Bluetooth Device - Panasonic RP-HF400B Instrucciones De Funcionamiento

Charging

The rechargeable battery (installed in the unit) is not charged initially. Charge
the battery before using the unit.
1
Connect this unit to a computer
using the USB charging cord
• The LED will light in red.
• The LED lights in red when charging
is in progress. When charging is
completed, the LED will go out.
• Charging will take approximately
2.5 hours from empty state to fully
charged.
■
Note
• The Bluetooth feature cannot be used when this unit is connected to a computer
®
using the USB charging cord.
• Charge in a room temperature between 10 °C and 35 °C.
• The power cannot be turned on while charging.
• Do not use any other USB charging cords except the supplied one.
Caution: Use only the supplied USB charging cord when connecting to a computer.

Turning the power on/off

1
In the power-off state, press and hold the
power button of this unit for approx.
3 seconds until the LED (blue) blinks
• A beep will sound, and the LED (blue) will blink
slowly.
To turn the power off
• Press and hold the power button for approximately 3 seconds. A beep will
sound and the power will be turned off.
■
Note
• When the unit is not operated for approximately 5 minutes, the power will
automatically turn off. (See "Auto power off" (→ P. 6))
4
4
RP-HF400B_E(TQBM0093).indb RP-HF400B_E(TQBM0093).indb 4 4
LED
Computer
USB charging cord (supplied)
LED
Power button
Connecting a Bluetooth

Preparation

• Place the Bluetooth ® device within approx. 1 m from the unit.
• Check the device operation using its operation instructions as required.
Pairing (Registration) this unit with the Bluetooth
connection
1
Press and hold the power button of this unit until the LED blinks
When pairing a device for the first time
When pairing a second or subsequent devices : approx. 5 seconds
• The unit starts to search for the Bluetooth
LED will blink in blue and red alternately.
2
Turn on the power of the Bluetooth
Bluetooth function
®
3
Select "RP-HF400B" from the
Bluetooth device's menu
®
• The MAC address "□□□□□□" ("□" stands for a
character that is unique to each set.) may be
displayed before "RP-HF400B" is displayed.
• If prompted for a passkey, input the passkey
"0000 (four zeros)" of this unit.
4
Check the connection with the
Bluetooth device on the unit
®
• The LED will blink in blue and red alternately until the connection
with the device is completed. When the LED (blue) blinks twice
every approx. 2 seconds, pairing (registration) is completed.
(Connection established)
■
Note
• If connection to a device is not established within approximately 5 minutes, the
unit will be turned off. Perform pairing again.
• 2 or more Bluetooth devices cannot be registered to the unit at the same time.
®
• You can pair up to 8 Bluetooth devices with this unit. If a 9th device is paired,
®
the device with the oldest connection will be replaced. To use it, perform pairing
again.
device
®
® device for
: approx. 3 seconds
® device for connection, and the
® unit, and enable the
(Ex.)
Bluetooth
Bluetooth ON
Device
Select
RP-HF400B
2017/03/17 2017/03/17 21:21:32 21:21:32