D Using Your Dispenser; Start-Up; Setting Internal Temperature Of Your Product - Ugur USS 85 Guia Del Usuario

All manuals and user guides at all-guides.com
D- USING YOUR DISPENSER

Start-up

WARNING!
• This operating manual applies for various device models. Hardware scopes of the models may vary. There
may be diff erences in the pictures.
• Clean inside and all accessories of your product before the first start up (see Cleaning Your Product).
• If your product has been shaken so much during the transportation and positioning, wait for one (1) hour
without running it. Thus, the compressor oil, which may enter into the system, will return back. You may
damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has been
installed according to the regulations. (Picture 8)
• You will hear a slight sound from the compressor and fan when your product is running.
PICTURE 8
Setting the Internal Temperature of your Product
Internal temperature of your device has been factory set in a manner that it runs under every environment.
Thermostat of your product is at the compressor section and it can be set in any temperature you desire.
When you run your product at factory set value, you get the best result in terms of both the performance
and energy consumption.
37
EN