>
Now push the spike of the drip tubing
into the earth, close to each of the
plants to be watered. The water
leakage takes place in the intersection
between the drip tubing and the spike.
>
To deactivate a drip tube, withdraw
the respective tube and then seal the
exit opening with one of the bungs
secured to the tube.
>
Connect the free end of the garden
hose
with the tap valve on a water
barrel. The tap valve must be located
at least 35 cm higher than the area
to be irrigated, otherwise the water
pressure will not be sufficient.
>
Open the tap valve and then check
the installation for imperviousness and
correct water issuance.
Maintenance
>
There is a filter installed in the
connector piece
flow be interrupted, remove the hose
piece connected to the screw cap
housing. Then unscrew the screw cap
with the filter housing and clean the
filter.
>
When clean, reassemble the screw
cap and then firmly reinsert the
previously removed hose piece.
. Should the water
Apart from this, the appliance
is maintenance-free. No form of
maintenance, either on or in the device,
is intended for execution by the user.
In the event of malfunction or apparent
damage, make contact with Customer
Services.
Disposal
Dispose of all packaging materials
in an environmentally friendly
manner.
Importer / Service
KOMPERNASS GMBH
BURGSTRASSE 21
44867 BOCHUM, GERMANY
www.kompernass.com
- 6 -