Installer Setup - Honeywell Home PRO 3000 Serie Instrucciones Para La Instalación

Installer Setup

Follow the procedure below to
configure the thermostat to match
the installed heating/cooling system,
and customize feature operation as
desired.
To begin, press and hold the
buttons until the display changes.
t
• Press t to change settings.
• Press s to advance to next
function.
• Press and hold
save settings.
Setup function
1 System type
TH3110D only
5 Heating cycle rate
(CPH: cycles/hour)
TH3110D only
6 Auxiliary heat
cycle rate (CPH)
TH3210D only
8 Emergency heat
cycle rate (CPH)
TH3210D only
9 Compressor
cycle rate (CPH)
14 Temperature
display
15 Compressor
protection
Compressor Protection (Setup Function 15): Forces the compressor to wait a few minutes
before restarting, to prevent damage. During the wait time, the message Cool On or Heat On
(heat pumps only) will flash on the display.
and
s
ts to exit and
Settings & options (factory settings in bold)
0 Gas, oil or electric heat with air conditioning
1 Heat pump (5 minute compressor off time in heating and
cooling)
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
9 For electric emergency heat
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
5 For gas or oil furnaces of less than 90% efficiency
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5, or 6 CPH]
0 Fahrenheit
1 Celsius
5 Five-minute compressor off time
[Other options: 0, 1, 2, 3 or 4-minute off time]
1
Function
number
5
Setup
0
Setting