Input Sensitivity; Output Level - König Electronic KN-DJMIXER60 Manual De Uso

11. Input level slider:
Control the level for the CH-1 and CH-
12. Led indicator:
Display the level of the input
13. Crossfader slider:
This slider is used to fade between the two signals at each end of the cross fader. Can be removed
for replacement.
14. Pre-fader listening facility via headphones (CUE):
The pre-fader listening facility allows to monitor the input channels via stereo headphones
connected to the jack, even if the respective channel is faded out.
(1) SPLIT-MIX Selector: Select between the  modes
SPLIT: The output to headphone is in mono, left side for the listening of channel 1 input; the
l
right side for channel .
MIX: The output to headphone is in stereo and mixed with  chan () SLIDER: Control the
l
headphone output volume between the right and left sides
Sliding the button to right side, the headphone right side output is fading in, and the left side is
l
fading out.
Sliding the button to left side, the headphone left side output is fading in, and the right side is
l
fading out.
15. Headphone:
Headphone jack.
16. Microphone:
Microphone jack.
17. dB selector switch:
Use to select the required
db output for the microphone.
ON: Music reduce 10 dB
TALKOVER: talking from Mic,music reduce 10 dB.
OFF: Mic channel without priority.
Specifications:

INPUT SENSITIVITY

Mic: m V
Phono: 3mV
Line: 00m V

OUTPUT LEVEL

Master: .5 ±0.5 V
Headphone: 1.5±0.3 V 3 Ohm
GENERAL
Frequency response: 0 Hz~0 KHz±3 dB (RIAA±3 dB)
S/N Ratio: 60 dB
CH Balance: less than .5 dB at 1 KHz
THD: less than 0.09% (1KHz) OUTPUT LEVEL
Master: .5 ±0.5 V
Headphone: 1.5±0.3 V 3 Ohm
Weight: 1.9 Kg
Dimensions: 70 (L)*177.8 (W)*85 (H)mm