Voice Connect Feature (Vox); Reset Pairing (Restoring The Original Default Configuration); Noteworthy Issues; Troubleshooting The Intercom - SCHUBERTH SRC‑System Guía De Usuario

NOTe: while the Intercom is on, the Redial and Voice Dial functions will be
disabled.

9.7 VOICE CONNECT FEATURE (VOX)

The SRC‑System™ also offers VOX technology for safe and hands-
free operation of some key functions.
For incoming calls, just pronounce loudly any word (e.g. "hello").
To reject an incoming call, you need only to remain silent for about
15 seconds.
To reject an intercom call remain silent for 30 seconds.
eNABLe/DISABLe VOX: while on standby press and hold the Vol-
ume Up and Volume Down Buttons simultaneously for three seconds
until you hear a beep. The default status is Voice Connect enabled.
NOTe: The enable/Disable Voice Connect feature affects only the Intercom
functionality.
9.8 RESET PAIRING (RESTORING THE ORIGINAL DEFAULT
CONFIGURATION)
This section is only relevant once you have completed a pairing process
You can delete all of your paired devices at any time as follows:
1. with the SRC‑System™ headset turned ON, press and hold the
Mobile Button for at least six seconds until the Red and Blue Lights
begin rapidly alternating.
2. Press and hold the Volume Up Button for three seconds.
3. The Red and Blue Lights will flash five times simultaneously and
then the headset will turn off, confirming that Reset was success-
fully completed.
QG SRC 207 - MAN00015 indd 35

9.9 NOTEWORTHy ISSUES

a. Busy Status (When using a SRC-System™ headset)
when attempting an Intercom call with a headset that is already on
a Phone/ GPS/ Intercom call, you will hear two beeps indicating the
other headset is busy.
b. Automatic Reconnection of the Intercom
If the SRC‑System™ and another paired headset go out of range and
disconnect from each other, the SRC‑System™ will immediately try
to reconnect to the other headset.
You can manually reconnect the intercom call while the headset is
in Standby mode by pressing the CHANNEL "A" or the CHANNEL "B"
Button to connect to the respective lost connection.
c. Conference mode Limitations
whenever you enter the Intercom Conference mode among three
participants (including yourself), the participants who maintain
simultaneously two active connections will not be able to receive
mobile phone calls or GPS messages as long as the conference call is
in progress (see details in sections 9.4 b).

9.10 TROUBLESHOOTING THE INTERCOM

First, make sure your microphone is located properly in front of the
center of your mouth.
The SRC‑System™ is designed for use in loud environments.
Therefore, you should test the Intercom functionality only in a noisy
environment, such as next to an idling motorcycle and not indoors.
Please also verify that the headsets were paired together properly by
following the instructions in the relevant Setup sections.
35
2/1/11 11 38 AM