Side Discharge - Craftsman 98820 Manual Del Usuario

attaching upper handle (figure h)
• Remove the upper-handle attachment
levers (5), nuts (20), and washers (21)
from the handle.
• Line up the holes on the bottom of the
upper handle (3) with the holes on the
top of the lower handle (4).
H
20
4
nOte: Make sure the cord is located on
the front of both handles. If it is not it may
result in the cord tangling and the inability
to easily store the
mower (figure i).
• From the outside
of the upper
handle (3), slide
the lever bolt
through the holes.
• Slide the washer
over the bolt of the
lever and loosely
assemble the
entire assembly
with the nut.
• Rotate the upper
handle into its
operating position.
• Close the lever. If it is too tight or too
loose, open the lever and the nut to adjust
the clamping. check the levers by closing
them. They should be tight enough so the
handles are held firmly, but loose enough
so the levers can be fully closed. Adjust
by opening the lever and turning the nut
until the handles are secured.
Securing the MOtOr cable
(figure j)
CAUTION:
ATTAch cAblE SO
ThAT IT dOES NOT bEcOME
STRETchEd OR PINchEd IN ThE
jOINTS Of ThE hANdlES dURINg USE
OR fOldINg. ThIS cAN cAUSE
dAMAgE TO ThE cORd.
The motor cable (22) has to be fixed to the
handles using the cable restraints (23) that
are already attached to the handle.
To clip the cable to the handle:
• Place the handles in operating position,
see "Attaching lower handle" section.
• Run the cable up the front of the lower
3
21 5
I
and upper handles.
• Pull back the cable restraint.
• Slide the motor cable under the clip and
ensure it is fully held in place by the restraint.
j
23
bagging
• Ensure the side discharge attachment
(27) (figure M) and the mulching insert
(26) (figure l) are removed from the
mower before bagging.
• lift the rear door cover (9) and place the
grass collection bag (8) onto the mower
so the bag hooks (24) rest on the lugs
(25) as shown in figure k. Then lower
the rear door cover.
k
9
Mulching
• Ensure the side discharge attachment (27)
and the collection bag (8) are not attached.
• lift the rear door cover (9) and slide the
mulching insert (26) fully into the mower
as shown in figure l.
• Ensure the rear door cover fully closes
before turning mower on.
L
Side diScharge
• Ensure the collection bag (8) is removed.
• lift the rear flap (9) and slide the
mulching insert (26) fully into the mower
10
22
8
24
25
26