Publicidad
Idiomas disponibles
Idiomas disponibles
G Operating instruction
We are delighted that you have chosen a
Pazzimo product.
Please take a moment to carefully read through
the following points.
Keep the operating instructions safe in case you
need to use them for reference.
The stereo phono preamplifier is suitable for
connecting record players with magnet systems
to high-level inputs. You can also use a normal
high-level input (line in, aux, CD, tuner, tape,
etc.) as an additional record player input with
it. With the stereo phono preamplifier, you can
connect a record player to your PC sound card.
RIAA equalisation is also included.
1. Please observe the following:
• The product is intended for private use, not
for commercial use.
• Protect the product from dirt, moisture and
overheating, and only use it in dry locations.
• It is important that you never drop the product.
• Like any technical product, the product has
performance limits. You can look them up
in the technical specifications. Do not use it
outside these values.
• If the product is damaged, do not continue
to use it and do not open it yourself. There
is a risk of injury through electric shocks,
for example.
• Only connect the product to a socket that has
been approved for the device. The socket must
be installed close to the product and must be
easily accessible.
• If you modify the product, the warranty
immediately becomes void.
• The product is not, of course, suitable for
children.
2. Getting started:
• First connect the left and right channels of
your record player to the left and right chan-
nels of the preamp's input. (MM/input)
• Ensure that your record player has a magnetic
pickup. The record player may have a sep-
arate ground wire – if so, connect it to the
extra screw on the back of the device.
• Then connect the left and right channels of
the preamp's output to the left and right
channels of the stereo amplifier's input (line
in, aux, CD, tuner, tape, etc.).
• Connect the preamp's power supply to finish.
Now you can use your record player and
amplifier as usual. Make sure that the correct
input is selected on your stereo amplifier.
• Note: Make certain to use a mains adapter
with the correct polarity. Otherwise it may
damage the device.
3. Now comes the technical part:
Don't worry – it's not as bad as all that. Simply
read through and observe the values below, and
nothing can go wrong when using the product.
Input resistance
Output resistance
Amplifier
Bandwidth
Signal-to-noise ratio
Crosstalk
Power supply
47 kOhm / 220 pF
1000 Ohm
40 dB
20 Hz to 20 kHz
70 dB
40 dB
mains adapter
Publicidad
