Sony ZS-D50 Manual De Instrucciones página 43

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Symptom
The picture of your TV becomes
unstable.
The tape does not move when you
press an operation button.
The r/P button does not
function/The tape does not play.
The tape does not erase completely.
The tape does not record.
The audio is weak/The audio
quality is poor.
The tape player cannot be paused
during playback.
The timer does not operate.
Remedy
• If you are listening to an FM program near the
TV with an indoor antenna, move the player
away from the TV.
• Insert the tape properly and close the tape
compartment securely.
• Replace all the batteries with new ones.
• Make sure the safety tab of the tape in the tape
compartment is in place.
• Press p on the TAPE section to switch the
function of the player to "TAPE".
• Clean the erasing heads (see page 45).
• The source which was recorded on TYPE II
(high position) or TYPE IV (metal) tape using
this unit is being played. Record on TYPE I
(normal) tape and play.
• Make sure the tape is inserted properly.
• Make sure the safety tab of the tape in the tape
compartment is in place.
• Clean the heads, pinch rollers and capstans (See
page 45).
• Demagnetize the heads using a demagnetizer
(see page 45).
• The tape player can be paused during recording
only.
• Make sure the time on the clock is correct.
• Replace all the batteries in the player including
the back-up batteries with new ones if they are
weak.
• Check to see if the AC power had been cut off.
• Make sure the tape has not wound to the end.
• Make sure the t (clock) indication is displayed.
continued
Additional Information
43
GB

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido