Warm Audio WA-MBA Guia De Inicio Rapido página 4

REFINE YOUR SETUP
Now that you have the MBA fully set up and your microphone is roughly in the right place, you can take the
time to get things looking and sounding perfect for your stream.
1. Sit down at your desk, and get your body into the position it will normally be in when you're streaming.
2. Determine the best place for the microphone to be placed for both sound quality concerns and on-camera
look (if you're using a camera). This will be different depending on the type of microphone you have and the
position of the camera and any lighting you're using, and may require some experimentation to get right.
3. Once you've determined the proper angle and orientation for the microphone, hold the mic again for safety,
and manipulate the three tightening bolts again to move it into the proper position. Make sure that the mic sits
properly, and that the adjustment bolts are secure so that the arm will not droop over time.
4. Now that your microphone is properly situated, you can clean up the final look by connecting the mic to its
cable and using the boom arm's internal channel to tuck the cable out of sight. The WA‑MBA ships with a
set of six plastic clips that are designed to securely hold the cable into the hidden channel, but before you go
any further it's a good idea to perform a "rough fit", tucking the cable into the channel all the way down to the
C-Clamp to see where you will want to place the clips. We suggest using three clips on the cable that will be
inserted into the channel on the lower boom arm section, and three clips for the cable to be inserted into the
upper section's channel.
4