Hamilton Beach 14670R Manual Del Usuario página 5

All manuals and user guides at all-guides.com
840205900 ENv02.qxd:840131800 ENv01.qxd
Fabric Setting Chart
Steam
Temperature Setting
Setting
Off
Nylon, Acrylic
Silk
Polyester
Wool
Rayon
Cotton, Linen
Caring for Your Iron
Iron
1. The water tank of your iron should
be emptied after each use. Turn
Temperature Control Dial to OFF
(O). Unplug the iron and hold over a
sink. Slowly tilt pointed end of iron
down over sink. Water will run out
of water tank opening.
2. After iron has completely cooled,
wrap cord loosely around the iron
and store in an upright position. Do
not store iron laying flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal
rivets, or snaps since these may
scratch the soleplate.
2. To clean occasional buildup on the
soleplate, wipe with a sudsy cloth.
Do not use abrasive cleansers or
metal scouring pads.
3. Always store iron upright in the heel
rest position.
10/28/11 11:22 AM
Ironing Instructions
Dry iron using spray if necessary.
•
•
Dry iron on the wrong side of the fabric.
Iron while fabric is still damp.
••
Use a press cloth and steam iron on the
••
wrong side of fabric.
•••
Iron using spray if necessary.
For cotton, iron while still damp or use
•••
spray. For linen, iron fabric on wrong side.
Self-Clean
To keep the steam vents clear of any
buildup, follow these instructions each
time you iron using steam.
1. Turn Temperature Control Dial to OFF
(O) and set Adjustable Steam Switch
to Dry Iron
1⁄2 of its maximum capacity.
2. Turn Temperature Control Dial to
Linen setting and let iron heat for 2
minutes. Keep Adjustable Steam
Switch on Dry Iron
3. Turn Temperature Control Dial to
OFF (O ). Unplug iron and hold over
a sink with soleplate facing down.
4. Turn Adjustable Steam Switch to
MAX, while pressing Blast of Steam
button often. Boiling water and
steam will flow out of steam vents.
Allow all water to drain from iron.
5. Gently move iron front to back to allow
water to clean entire soleplate area.
6. If water still remains inside of sole-
plate, reheat iron as indicated in
Step 2. Boiling water and steam
could still flow out of steam vents.
Page 5
. Fill iron with water to
.
5