Recommendations For Use - GAMA BARBER STYLE Manual Del Usuario

to dispose of it, it should be taken to the proper collection
point for recycling electrical and electronic appliances.
When you dispose of this product correctly, you help
prevent potential negative consequences for the
environment and health, which could derive from improper
treatment of the product. For more detailed information
on recycling this product, contact the municipal office,
the local waste disposal service or the shop where it
was purchased.
LIMITED WARRANTY PERIOD:
Duration of warranty period: 1 or 2 years depending on
customer category, in compliance with European Directive
1999/44/EC.
For support service under warranty, please take the
original purchase ticket / sales receipt to the shop
where the product was purchased. The product will be
15
repaired free of charge or immediately replaced with
similar product of equal or greater value.
BARBER STYLE

RECOMMENDATIONS FOR USE:

Before using the hair clipper the hair must be clean and dry. We recommend cutting small quantities of hair at
a time, adjusting the cutting length gradually until finding the one you want. The blades risk getting stuck if too
fast movements are made or if a lot of hair is cut at the same time. It can be used without attachment comb
to trim beard, neck hair and sideburns.
BEFORE USING THE APPLIANCE:
Lubricate the blade before the first use. Read the instructions contained in the section "HOW AND WHEN TO
LUBRICATE THE BLADE"
Adjust motor power. After oiling the appliance, its operation could be inefficient; therefore it is necessary to
turn it on and follow the instructions given below to achieve optimal operation:
1- There is a black screw (Fig. 1) on the right side of the body of the appliance that can be used to change the
power of your hair clipper's motor. This screw has been previously calibrated in our production line; however,
depending on the voltage where the appliance is used, you may need to adjust it again. For this operation, you
will need a screwdriver to be inserted in the screw cavity.
2- Turn the screw clockwise until hearing the loud noise emitted by the motor when it reaches the maximum
speed; immediately after this, turn it anticlockwise until the motor noise decreases. Stop turning the screw
only when the blade is horizontally aligned with the head and not beyond.
3- At this point the motor power has been adjusted and the hair clipper is ready for use.
16