Shutting Down - Excell VR2522 Manual De Operación

Ocultar thumbs Ver también para VR2522:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

All manuals and user guides at all-guides.com
STARTING
Prior to starting, refer to your engine
manual for proper starting procedure.
1.
In a well ventilated outdoor area
add fresh, high quality, unleaded
gasoline with a pump octane rating
of 86 or higher. Do not overfi ll. Wipe
up spilled fuel before starting the
engine. Refer to Engine Owners
Manual for correct procedure.
2.
Check engine oil level. See
Engine Owners Manual for correct
procedure.
3.
Connect the water hose to the
water source. Turn the water source
on to remove all air from the hose.
When a steady stream of water is
present, turn the water source off.
4.
Verify the
Filter Screen
filter screen is
in water inlet of
pump. NOTE:
Cone side
faces out.
5.
Connect
water source to pump inlet. NOTE:
Water source must provide a
minimum of 5 gallons per minute at
20 PSI.
Water
Source
To reduce the
possibility of
contamination always protect against
backflow when connected to a potable
water system.
6.
Connect high pressure hose to
pump outlet.
7.
If applying a chemical or cleaning
solution, see How To Apply
Chemicals/Cleaning Solvents
instructions in this section.
8.
Turn water source on.
A16637
to do so could cause damage to the
pump.
9.
Remove all air from the pump
and high pressure hose by
depressing trigger until a steady
stream of water is present.
10. Start engine. See Engine Owners
Manual for correct procedure.
engine does not start after two pulls,
squeeze trigger of gun to relieve
pump pressure. Pull starter cord
slowly until resistance is felt. Then
pull cord rapidly to avoid kickback
and prevent hand or arm injury.
11. Depress trigger on gun to start
water fl ow.
a stable surface and grip gun/spray
wand fi rmly with both hands. Expect
the gun to kick when triggered.
12. Release trigger to stop water fl ow.
engage the
trigger lock
when gun is not
in use. Failure
to do so could
cause accidental
spraying.
High
13. Adjust nozzle spray for the task
Pressure
being performed. See How To Use
Hose
Hook-up
Wand instructions in this section.

SHUTTING DOWN

1.
After each use, if you have applied
chemicals, place chemical hose
into container of clean water and
draw clean water through chemical
injection system to rinse system
thoroughly.
to do so could cause damage to the
pump.
2.
Turn engine off. See Engine
Owner's Manual.
12- ENG
Risk of property
damage. Failure
Risk of unsafe
operation. If
Risk of unsafe
operation. Stand on
Risk of injury from
spray. Always
Trigger Lock Engaged
Risk of property
damage. Failure

Publicidad

Tabla de contenido
loading

Tabla de contenido