GE GXSHC40N Instrucciones De Instalación página 23

Programming the Water Softener
FEATURE: OTHER DATA DISPLAY
These models have an option to have the
run display indicate different information. The
information displayed on the top half of the
display can be changed to one of the following
by pressing UP
• CAPACITY REMAINING
– This is the percentage
of water softening capacity
remaining. Immediately
after a regeneration, 100%
shows. As water is used,
the percentage will decrease until the next
regeneration. During regenerations, the
percentage increments upward.
When present time is displayed, press the
DOWN button; % Remaining will appear in
the display. The value shown is between 0 and
100 percent. This value is based on current
operating capacity. Pressing the UP
will return the screen to the previous display.
• AVERAGE DAILY
GALLONS – The figure
displayed is the average
gallons of water used by the
household each day over
the past seven-day period.
Press the DOWN
the Average Daily Gallons. Average Daily
Gallons will appear in the display. This value
is updated every night at midnight. Pressing
the UP button will return the screen to the
previous display.
• FLOW RATE, GPM
– When using soft water,
this display shows the flow
rate passing through the
softener (in gallons per
minute). Zero shows if water
is not passing through the softener.
Press the DOWN
the flow rate. Gallons/Min will appear in the
display. This value is updated every
Pressing the UP
screen to the previous display. Pressing the
DOWN button will return the screen to the
present time display.
or DOWN buttons:
Days to Empty
Recharge
Tonight
Days to Empty
Recharge
Tonight
button again to display
Gallons/Min
Days to Empty
button again to display
1 2
button will return the
RESETTING TO FACTORY DEFAULT
To reset the electronic controller to its factory
default for all settings (time, hardness, etc.):
1. Press the MODE/SET button and hold
until the display changes twice to show the
flashing mode code.
2. Press the UP
"SoS".
% Remaining
3. Press the MODE/SET button and the
electronic controller will restart.
4. Set the present time, hardness, etc, as
described in the Programming the Water
button Softener section
Average Daily
Gallons
second.
23
button to display a flashing