Getting Started; Set Up Sensor - Oregon Scientific WTGR800 Manual Del Usuario

2 x Rectangular
2 x Round
Base Legs
U-Shaped
Bolts
3 x Tension Strings
3 x Pins
4 x Screws
2 x Screws
(Type A)
(Type B)
4 x UM-3/
1 x Cone-Shaped
AA End

GETTING STARTED

SET UP SENSOR

The sensor can take readings for:
• The wind speed and directions
• The outdoor temperature
• The outdoor relative humidity
• Heat index, wind chill and dew point level
The sensor is battery operated and is capable of
transmitting data to the base station wirelessly within an
approximate operating range of 100 meters (328 feet).
NOTE For best results, ensure that the wind direction
indicator on the wind sensor points to the North to
enable an accurate reading. The sensor also should
be positioned in an open area away from trees or other
obstructions.
To set up the wind sensor main body on the steel pole:
1. Assemble the wind direction pointer on the top of the
wind sensor.
2. Use the screw (Type B) to fix.
3. Assemble the wind vanes on the top of the wind
4. Use the screw (Type B) to fix.
5. Hold the wind sensor upright and rotate the
6. Slide the sleeve down to open the battery
1 x 1 x
Mid-
Bottom
7. Insert batteries (4 x UM-3 / AA) in the compartment,
Pole
Pole
8. Slide the protective sleeve up to close the
9. Rotate the sleeve to the right to lock.
To set up the steel pole support:
1. Assemble the "cone shape" guiding end with the
1 x Plastic
Support Base
2. Screw the guiding end clockwise at the bottom of
3. Remove the cover hole from the plastic base.
4. Insert the plastic base onto the steel pole until the
5. Use the screw that is already attached on the base,
6. Use the guiding end to start inserting the steel pole
cables / power lines, gas / water pipes in the area
where you are placing the steel pole. Do not place the
2
pointer.
1
2
protective sleeve to the left to unlock.
compartment.
matching the polarity (+ / -) and press RESET.
compartment.
5
6
bottom steel pole.
the pole.
1
2
screw hole aligns with the support.
with the washers and bolts to fix.
at a perpendicular angle into the ground.
WARNING Make sure that there are NO electric
4
3
7
8
9
3