Cleaning And Maintenance - Fagor MG-35 Manual De Instrucciones

• To assemble the 2/3/6 accessories, line
up the mark on the accessory with the
one on the appliance and turn 30º in a
clockwise direction (Fig. 2).
• Always clean the 2/3/6 accessories
after use. To remove, turn anticlockwise
and pull upwards. Clean with the brush
supplied.
• Combs 4/5 must be assembled in
accessory 3. These are assembled by
lining up one side with the notch in
accessory three, then pressing in until
the other side goes into the other notch.
(Fig. 3)
• When you have assembled the
accessory, Push the ON/OFF switch
upwards. The appliance will start
operating and you can start cutting your
hair.
Cutting the hair in the ear
Assemble accessory 6 and then switch on
the appliance.
Move the accessory carefully around the
parts of the ear with hair.
Cutting nasal hair
Assemble accessory 6 and then switch on
the appliance.
Remove nasal hair by carefully making
circular movements with the appliance.
Trimming sideburns or beard
Assemble accessory 2 and then switch on
the appliance. Move the spacing comb to
the length required (there are 5 positions).
To do this, press the click and slide to the
point required by pushing up or down
(Fig. 4). If you like you can remove the
spacing comb by pressing the clip and
pressing upwards until it comes off; to
assemble just slot it back into notches in
attachment 2.
Move the accessory in an acute angle over
the skin in a downward motion, without
applying pressure.
Do not move the unit in an upward or
sideways direction. You may cut yourself.
Cutting hair on the neck and chest
Assemble accessory 3 and then switch on
the appliance. If you prefer you can use
All manuals and user guides at all-guides.com
8
combs 4 or 5. Remember that if the hair
is too long it will cut with the sides of the
accessory and if it is short it will cut with
the central part.

5. CLEANING AND MAINTENANCE

To clean the accessories, first remove from
the appliance by turning anticlockwise and
pulling upwards. Then use the cleaning
brush supplied with the product.
After use, store the appliance and its
accessories In the stand supplied. If
the battery is not spent, do not plug the
charger stand into the mains.
6. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working
life, the product must not
be disposed of as urban
waste. It must be taken to
a special local authority
differentiated waste
collection centre or to a
dealer providing this service. Disposing of
a household appliance separately avoids
possible negative consequences for the
environment and health deriving from
inappropriate disposal and enables the
constituent materials to be recovered to
obtain significant savings in energy and
resources.
To remind you that you must collaborate
with a selective collection scheme, the
symbol shown appears on the product
warning you not to dispose of it in
traditional refuse containers.
For further information, contact your local
authority or the shop where you bought the
product.