Changing The Channel - Dvico TVIX T-441 Manual Del Usuario

Using TVIX HD TUNER
English
TViX R-3300
2. Channel scanning
① When installation is successfully finished,
Press SETUP-HDTV on your remote controller.
② To scan the channels, you can use the Start
Channel Scan menu on the SETUP-HDTV
menu.
To improve the picture quality in a poor signal
area, please purchase a signal amplifier and
install properly.
③ The channel scan takes about 5~6 minutes.
④ To stop the channel scanning, Click on
STOP(■) button on the remote control or select
the STOP on the scanning window.
⑤ After scanning, you have to configure the time
zone on SETUP-HDTV, If you want to use the
EPG guide, you have to set your time zone
correctly.
* Checking Digital signal Reception
① Press the INFO button on the remote control.
② The signal-strength meter will appear on the
INFO window.
③ If the meter indicates weak signals, adjust
your antenna to increase the signal strength.
Continue to adjust the antenna until you find
the best position with the strongest signal.

3. Changing the channel

Press CH +/- button to change the TV channels.
You can also enter the channel number by using
the numeric keypad on the remote and the
channel will change after a few seconds.
You can also enter the channel number by using
the numeric keypad on the remote and the
channel will change after a few seconds.
Previous Channel( SHUFFLE button).
To check the scanned-channel list, press
the GOTO button in TV mode. You can
change the channel by using Up/Down and
OK button.

All manuals and user guides at all-guides.com