Ketra HW-X96-X-J1 Guia De Instalacion página 8

I N S TA L L AT I O N
S T E P 3
Output Wiring
1. Strip away a minimum of 1 in (25 mm) of the outer cable jacket from the 4-conductor cable
(QSH-CBL(P)-M or equivalent.).
2. Separate each conductor.
3. Strip ¼ in (6 mm) of insulation from each conductor .
4. Install the connector by arranging the four conductors by color and number according to the
diagram below. Depress the plunger on the plug, insert the wire, and then release the plunger.
NOTE: Pliers can be used to depress plungers if needed.
Press here, insert wire, release.
Red
White
Purple
Black
8 | X96 INSTALLATION GUIDE
COM
P/N 3662641 Rev A
© 2021 Lutron Electronics Co., Inc.