Publicidad
Idiomas disponibles
Idiomas disponibles
2. To adjust the side handle height, install one bolt
(OO) per side in either of the hole options shown
below.
OO
Installing the Bumpers
Attach each bumper (LL) to the posts using two
screws (II) per bumper.
NOTE: Bumpers cannot be installed where the side
handle is located.
Attaching the Storage Trays
Attach each storage tray by hooking them onto the
slots of the posts. The trays can be installed on either
the inside or outside of the posts.
Installing the Storage Bar
1. Remove the bolt (JJ) from the storage bar.
2. Place the storage bar through any of the round
slots in the desired post, as shown. Then reinstall
the bolt (JJ) at the end of the rod.
II
II
LL
JJ
5
Installing the Tooling Cups
Attach each tooling cup by placing them in the top
tray frame slots, and twisting to lock.
Installing the Cord Storage Brackets
Attach the cord storage brackets (KK) to the station
using two screws (DD) per bracket.
USB Power Outlet
The USB ports on the power outlet can be used to
charge any device that uses less than 2.1A of DC
electrical current.
NOTE: Any device that uses more than 2.1 A of DC
electrical current will trip a self-resetting overload
and disable the output.
OPERATION
To avoid injury or property damage,
WARNING
do not exceed maximum drawer
capacity. Use care when moving the station on
incline or rough surface. Station may tip if weight
is not evenly distributed front to back and side
to side. Place more than half the total load weight
on the bottom drawers when possible.
Using the Lower Tray
The lower tray can be loaded to 200 lbs. To avoid tip-
ping, the slides have limited travel. Distribute weight
evenly from front to back and side to side.
Locking and Unlocking the Station
NOTE: The drawers must be fully closed before lock-
ing/unlocking the unit. Locks are located on both the
top and bottom tray frames.
Insert the key. Turn it fully left to lock, or fully right
to unlock. Always remove the key after locking and
unlocking.
Using the Fold-Out Work Tray
To use the fold-out work tray, pull it out and secure
to the station by latching the bottom half to the tray
tabs, as shown.
Publicidad
