Metra Electronics AXVI-1788 Manual Del Usuario

Dodge Sprinter 2008-2009 /
Freightliner Sprinter 2008-up
Accessory and NAV Output CAN Interface
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Prewired AXSWC harness (AXSWC sold separately)
• Retains balance and fade
• USB updatable
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator
lights must be connected before cycling the ignition. Also, do not remove the factory radio with
the key in the on position, or while the vehicle is running.
• Connect the Yellow wire to the radio's 12 volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Connect the Red wire to the ignition wire of the aftermarket radio.
• Connect the Orange wire to the illumination wire of the aftermarket radio. If the
aftermarket radio has no illumination wire, tape off the Orange wire.
• Connect the Blue wire to the antenna turn on wire of the aftermarket radio.
• Connect the White wire to the left front positive speaker output of the aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the aftermarket radio.
1-800-221-0932
REV. 1/21/20
AXVI-1788
AXVI-1788
FEATURES
Connections to be made
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
metraonline.com