Metra Electronics Axxess Integrate AXBUCH-T3 Instrucciones De Instalación

Toyota Back-Up Camera Retain/Add-On 2013-2016
INTERFACE FEATURES
• Retains the factory back-up camera to an aftermarket radio
• Allows an aftermarket camera to be added to the factory screen*
* Display and navigation model radios only
INTERFACE COMPONENTS
• AXBUCH-T3 harness
Scion Toyota (Cont)
FRS 2016
Avalon
iM 2016 Camry
tC 2016 Corolla
Highlander
Toyota
Prius C
4-Runner 2014-2016
Prius V
4-Runner (without NAV) 2013
Rav-4
TOOLS REQUIRED
• Cutting tool • Tape • Crimping tool
• Connectors (example: butt connectors, bell caps, etc.)
Integrate • AxxessInterfaces.com
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
AXBUCH-T3
INSTALLATION INSTRUCTIONS
APPLICATIONS
Toyota (Cont)
2015-2016 Rav-4 (after build
2014-2016 date Nov. 2013)
2014-2016 Sienna
2014-2016 Sequoia
2015 Tacoma
2015 Tundra
2015-2016 Venza
REV. 12/12/19
The AXBUCH-T3 can be connected two different ways
To retain the factory back-up camera to an aftermarket radio:
• Connect the Black wire to chassis ground.
• Connect the Yellow wire to accessory power. *
• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle.
• Disregard the loose Green/Purple wire, it will not be used in this application.
* It is highly recommended to use the AXCSD-6V (sold separately) to provide the camera with
the proper voltage.
To allow an aftermarket camera to be added to the OEM screen:
• Connect the Black wire to the ground wire of the aftermarket camera.
• Connect the power wire of the aftermarket camera to accessory power.
• Tape off and disregard the Yellow wire, it will not be used in this application.
• Connect the female Yellow RCA jack to the aftermarket camera.
2014
2015
The following (2) steps are only required if a wire is
2014-2016
not present in the factory harness.
2014-2016
*Except Avalon 2013-2014 and Venza 2013-2014
2014-2016
• If a wire is not present in pin-2 of the 28-pin
2015-2016
connector of the factory radio, unplug the
connector, then insert the metal pin of the
loose Green/Purple wire into it. Connect the
harness back into the radio.
• Connect the other end of the loose Green/
Purple wire to the reverse wire of the vehicle.
INSTALLATION INSTRUCTIONS
Connections to be made
14 13 12 11 10 9 8 7 6 5 4 3 2 1
28 27 26 25 24 23 22 21 20 19 18 17 16 15
This is the wire view of the connector
Integrate • AxxessInterfaces.com
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
AXBUCH-T3
28 Pin Harness
in the vehicle
REV. 12/12/19