ScorpionExo EXO-100 Manual De Usuario página 3

EN
SpeedView® Internal Sunvisor
Gently pull down the internal sunvisor on the
tab (located on the left-hand side of the
helmet) to lower the sunvisor.
Peak Visor Removal And Installment
Find the notched button on the side bracket, which holds the outer visor in place.
Slide the button with one hand, and with the opposite hand, pull the outer visor forward.
DO THIS FOR BOTH THE LEFT AND RIGHT SIDES.
To put the outer visor back on, slide the button back again, and fit the connecting parts of the
outer visor back into the slots. The button will slide forward, locking it into place.
TEST TO MAKE SURE THAT IT IS SECURE BEFORE RIDING.
DO NOT ATTEMPT TO USE WHILE RIDING
3
Gently press up the internal sunvisor on the tab
(located on the left-hand side of the helmet) to
retract in and lock sunvisor in place.
Liner Removal And Installment
CROWN LINER REMOVAL
First, your helmet should be positioned upside-down with the front
facing away from you, and on a soft, supportive surface that will not
damage your helmet's finish or structural integrity.
The arms of the chinstrap should be also be out of the neck-liner
harness.
At the back of the helmet pull the crown liner away from the shell by
unsnapping two snaps. Now the crown liner can be lifted out of the
center of the helmet.
Pull out the plastic arch from the bracket embedded in the front of the
EPS foam liner of the helmet interior.
NECK LINER REMOVAL
(EXO-100 ONLY: NOT AVAILABLE FOR EXO-100 PADOVA SERIES)
Locate the zipperhead inside the left-hand side of the helmet (on the
same side as the red chinstrap locking mechanism), and unzip it
throughout the back of the helmet. Unfasten velcro tabs in temple-area
of neck liner.
Detach the neck liner completely from the zipper, and set it aside.
EN
Plastic Arch
Crown Liner
Chinstrap Arm
EPS Foam Liner
Zipper head
4