Technical Data; Electrical Safety - BGS technic 9928 Manual Del Usuario

Cordless Impact Wrench, extra short

TECHNICAL DATA

Brushless and electronically controlled motor
Max. loosening torque: 250 Nm
Max. working torque: 200 Nm
Rated impact: 0 - 3200 bpm
Rated speed: 2500 rpm
Max. drive speed: 2600 rpm
Output profile: External square
Drive profile size: 12.5 mm (1/2")
Battery: Li-Ion 18V, 2 Ah
Sound pressure level: LWA=99.8dB(A)
Sound power level: LWA =110.8dB(A)
Vibration level: ahd=9.1731 ms²
Length: 170 mm
(incl. external square drive)
Weight: 1060 g
(only machine without battery, charger, BMC)
Gross weight: 3200 g
(machine, battery, charger, BMC)
EQUIPMENT (optional)
BGS 9929 - Replacement battery
BGS 9932 - Replacement quick charger
ATTENTION
Read all safety warnings and all instructions carefully. Follow all safety information and operating
instructions. Failure to follow the warnings and instruction may result in electric shock, personal injury and
property damage. Keep this manual for future reference in a dry and safe area.

ELECTRICAL SAFETY

WARNING! When using mains-powered tools, basic safety precautions, including the following, should
always be followed to reduce risk of fire, electric shock, personal injury and material damage. Read the
whole manual carefully and make sure you know how to switch the tool off in an emergency, before
operating the tool. The charger has been designed for 230V - 240V only. Always check that the power
supply corresponds to the voltage on the rating plate. If the supply cord is damaged, it must be replaced
by an electrician or a power tool repairer in order to avoid a hazard. Always use an approved extension
lead suitable for the power input of this tool. Before use, inspect the extension lead for signs of damage,
wear and ageing. Replace the extension lead if damaged or defective.
Note: Double insulation does not take the place of normal safety precautions when operating this tool.
The insulation system is for added protection against injury resulting from a possible electrical insulation
failure within the tool.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
K=3 dB(A)
K=3 dB(A)
K=1.5 ms²
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 9928
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed