Installation Instructions - Conairphone SW114 Manual Del Usuario

All manuals and user guides at all-guides.com
GET TO KNOW YOUR CONAIRPHONE
I. Flash Key
2. Mute Key
3. Redial Key
4. On/Off Key
5. Transmitter (Mouthpiece)
6. Ringer On/Off
7. Tone/Pulse Switch
8. Receiver Volume Control (Norm/High)
9. Heavy Duty Cord
10.Universal Keypad
11.Interchangeable Faceplate
Fig A
4
REMOVE FACEPLATE
Use a coin to remove the faceplate as shown
below. (See Fig B).
Fig B
REPLACE FACEPLATE
Just attach the faceplate as shown below
(See Fig C).
Fig C
5
INSTALLATION
INSTRUCTIONS
1. Never install telephone wiring
during a lightning storm.
2. Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet
locations.
3. Never touch uninsulated
telephone wires or terminals
unless the telephone line has
been disconnected at the network
interface.
4. Use caution when installing or
modifying telephone lines.
Preparation
First carefully remove your CONAIRPHONE TM
from the clamshell. In addition to the handset,
each clamshell contains the following
accessories:
• One 10 ft. straight telephone line cord
• Two additional interchangeable faceplates
• Owner's Manual
• Warranty Card (Part of Owner's Manual)
Important Notice
Your CONAIRPHONE TM will operate on all
systems, true tone or rotary.
1. If your home is wired for rotary service, move
Tone/Pulse switch to Pulse position (P).
2. If your home is wired for tone service, move
switch to Tone position (T).
6