Panasonic AJ-YA935G Guia De Instalacion página 4

Installing the board
CAUTION:
These servicing instructions are for use by qualified service
personnel only. To reduce the risk of fire or electric shock do not
perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.
1
Disconnect the power cord from the
unit.
2
Remove the 2 coin screws, then
remove the top panel.
3
Loosen the screw indicated in the
diagram below, then remove the
board clamp.
4
Insert the analog video input board
into the slot marked F2 located on
the rear panel side of the unit.
3 (E)
Board clamp
Coin screws
Screw
F2