ESCALADE Atomic G01354W Instrucciones De Montaje página 11

4 pcs - H5 Phillips Flat Head Screw
6 pcs - H6 Phillips Flat Head Screw
8 pcs - H14 Phillips Round Head Screw
STEP 10:
Attach P4 Chrome Goal onto P2 End Apron using H14 Screws as shown in FIGURE 10. Tighten, but do not
strip out H14 Screws. IMPORTANT NOTE: Make sure each P4 Chrome Goal is "seated" all the way
back into end apron before installing H14 screws - Otherwise - the soccer men may hit the edges of
chrome goal.
Attach P10 Scorers onto the top of P2 End Apron using H5 Screws as shown in FIGURE 10.
Tighten, but do not strip out H5 Screws.
Attach P15 Rod End Caps to the rod as shown in FIGURE 10.
Slide P16 Rod Handle onto each rod end with the small hole as shown in FIGURE 10.
IMPORTANT NOTE: A small amount of liquid soap applied inside each P16 Rod Handle will allow them
to slip onto rod easier.
Attach P17 Ball Entry Cups onto P1 Side Aprons
using H6 Screws as shown in FIGURE 10 and
DETAIL B. Tighten, but do not strip out H6
Screws.
Hole /
Handle End
P16
P15
FIGURE 10
All Rights Reserved.
© 2012 Escalade Sports
All manuals and user guides at all-guides.com
THIS STEP REQUIRES FOUR OR MORE ADULTS.
VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON
ITS LEGS. BE CAREFUL. THE TABLE IS VERY HEAVY.
PARTS REQUIRED:
2 pcs - P4 Chrome Goal
2 pcs - P10 Scorer
8 pcs - P15 Rod End Cap
H5
H5
P10
P4
H14
For Customer Service Call 1-888-996-2729
11
8 pcs - P16 Rod Handle
2 pcs - P17 Ball Entry Cup
NOTE: Use a short
phillips screwdriver
to install these H14
Screws.
P2
P1
DETAIL B
P17
H6