BGS technic 3328 Manual De Instrucciones página 6

LUBRICATION & MAINTENACE
•
Give 4 to 5 drops of pneumatic device oil into the pneumatic device via the air connection.
•
Check the pneumatic device before each using. The product must not be used if it shows cracks,
leaks or other damage.
•
Only use the pneumatic device if it can be controlled by the trigger, a jammed trigger carries a
risk of property injury and damage.
•
Only clean the pneumatic device with a dry cloth, do not use solvents, acidic cleaners, etc.
•
Do not immerse the pneumatic device in any liquid.
TROUBLESHOOTING
Probable Cause
Dirty or clogged air
passages
Insufficient air supply
Air leakage
Worn/damaged wear & tear
parts
Tool matching
DISPOSAL
Dispose of this product in an environmentally friendly manner at the end of its life.
Recycle unwanted materials, such as packaging, instead of disposing of them as waste.
Contact your local solid waste authority for recycling information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
(Insufficient power)
Flush and lubricate tool, drain air tank and supply line
Increase line pressure, make sure compressor matches tool's air
pressure and consumption needs
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Replace as necessary
Be sure you are using a tool suited for the sanding requirements of
the job at hand.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Solution
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed