Wolf Garten GT-S 2-27 Manual Del Usuario página 22

Cause
Ignition switch set to OFF
Fuel tank empty
Intake pump not depressed adequately
Engine flooded
Old or incorrectly mixed fuel
Dirty spark plug
Cause
Air filter blocked
Old or incorrectly mixed fuel
Carburettor incorrectly adjusted
Cause
Old or incorrectly mixed fuel
Carburettor incorrectly adjusted
Cause
Cutting head entangled with grass
Dirty air filter
Old or incorrectly mixed fuel
Carburettor incorrectly adjusted
Cause
Cutting head entangled with grass
No line in the cutting head
Coil jammed
Cutting head dirty
Line fused together
Line twisted when wound up
Not enough line released
If you have any further questions, please contact your authorised dealer on site.
All information, diagrams and specifications in these operating instructions are based on the latest product information
at the time of going to press. We reserve the right to make changes without prior notice.
22
Troubleshooting
Engine does not start
Engine does not run constanly at no load
Engine does not accelerate
Engine has no power or stops during cutting
Cutting head does release line
Procedure
Set switch to ON.
Fill fuel tank.
Slowly and fully depress the intake pump 10 times
On appliances with a choke lever:
Implement the starting process with the choke lever
in the operating position.
On appliances without a choke lever:
Press the throttle and pull the starter cable.
Empty the tank/fill with fresh fuel mixture.
Replace or clean spark plug.
Procedure
Clean or replace air filter.
Empty the tank/fill with fresh fuel mixture.
Have carburettor adjusted by customer service personnel.
Procedure
Empty the tank/fill with fresh fuel mixture.
Have carburettor adjusted by customer service personnel.
Procedure
Stop the engine and clean the cutting attachment.
Clean or replace air filter.
Empty the tank/fill with fresh fuel mixture.
Have carburettor adjusted by customer service personnel.
Procedure
Stop the engine and clean the cutting attachment.
Wind up new line.
Replace coil.
Clean coil and coil housing.
Pull apart, take out the fused part and wind up the line again.
Pull apart and wind up the line again.
Tap the bump head and pull out the line until 10 cm of line is
outside the cutting attachment.