Southwire RCT-D1 Guia De Inicio Rapido

RCT-D1 Ratchet Crimp Tool
fo
r Coax Cable TV "F" Hex Connector
WARNING:
Tool is not insulated. Never use tools
on live circuits. Wear eye protection when using tools.
Keep fingers away from mechanism while using tool.
Figure 1.
0.213 "
cavity
0.319"
cavity
0.256 "
cavity
0.068"
Contact
pin crimp
Instructions
1. Install the connector onto a properly prepared cable
according to the connector manufactuer's instructions.
2. Place the cable/connector assembly into the
proper die cavity.
3. Squeeze the handles until the ratchet cycle is
complete.
4. Release pressure on the handles to open the tool
and remove the crimped connector.
5. If the tool jams in the crimp cycle, push the
ratchet release lever to open up the tool.
Replacing Die Set (D1)
Southwire offers replacement die sets, as well as
die sets for different cable/connector types.
Observe the position of the upper and lower dies
in the tool. Use a Philips screwdriver to remove the
two screws that hold the dies in place.
Remove old dies. Install new dies making
sure they are positioned properly.
Ratchet release Comfort Grip
Figure 2.
Phillips
screw
Die Set
Phillips
screw
is securely fastened.
Latch/Handle Lock
Scan for a how-to video,
warranty information and
to access our mobile site.
Escanea para video
WARNING:
Do not operate tool until die set
southwiretools.com
1-855-SW-T00LS
Toll Free Technical Help
Línea de Ayuda Técnica Gratuita
Contents Made in Taiwan
Product distributed by Southwire Company, LLC
One Southwire Drive, Carrollton, GA 30119
©2014 Southwire Company, LLC. All rights reserved.
04/14 Rev. 0