Linea 2000 DOMO DO91606W Manual Del Usuario página 35

USE
CONTROL PANEL
1. On/off button of the light
2. Button to raise the temperature
3. Display
4. Button to lower the temperature
5. Button for Celsius/Fahrenheit
6. On/off switch
· Press the on/off switch (6) to turn the appliance on or off.
· The temperature can be displayed in Celsius or Fahrenheit. To change this, press the Celsius/
Fahrenheit button.
· The desired temperature can be set using the buttons to raise or lower the temperature (2+4).
Pressing these buttons, the temperature will change with 1°C each time you push the button.
· The temperature can be set between 5-22°C (41-72°F).
· You can read the selected temperature on the display.
· You can turn on/off the lights inside the appliance by pushing the on/off button for the light (1).
MOVING THE APPLIANCE
· Remove all bottles from the wine cooler.
· Tape all loose parts to the inside of the wine cooler.
· Set the support feet at the bottom of the appliance to their lowest position to avoid damaging.
· Tape the door shut.
· Make sure that the appliance is kept upright during transportation.
MOVING THE SHELVES
· Empty the fridge before moving the shelves.
· The large wooden shelves are equipped with a telescopic runner assembly (except for the small
bottom shelf) and you can move the wooden shelves out and in smoothly.
· To prevent damaging the door gasket, make sure to have the door all the way opened when pulling
shelves out of the rail compartment. For easy access to the bottles, you must pull the shelves
approximately 1/3 out of the rail compartment.
· To remove the shelves out of the rail pull each shelf approximately 1/3 out. Use a long flat screwdriver
to press down the right plastic notch as shown in Figure A and at the same time lift the left plastic
notch as shown in Figure B. Then proceed to pull out the shelf slowly.
www.domo-elektro.be
1 2 3 4 5 6
DO91606W-DO91608W
35