Operation - Dometic MYFRIDGE MF1F Instrucciones De Uso

MF1F
If you want to fasten the bottle cooler with a self-tapping screw
➤ Drill a hole where you want to fasten the appliance.
To prevent damage when drilling make sure there is sufficient space on the other side for the
drill head to come out.
➤ Deburr the hole.
➤ Screw the self-tapping screw (fig. 2 2, page 3) through the opening in the bottom of the con-
tainer.
If you want to fasten the bottle cooler with a machine bolt
➤ Drill a hole where you want to fasten the appliance.
To prevent damage when drilling make sure there is sufficient space on the other side for the
drill head to come out.
➤ Push the machine bolt (fig. 2 3, page 3) through the opening in the bottom of the container
and fasten the bottle cooler with both washers (fig. 2 4, page 3) and the nut (fig. 2 5,
page 3).
If you do not want to permanently fasten the bottle cooler
➤ If you do not want to permanently fasten the bottle cooler, put the dummy plug (fig. 2 1,
page 3) in the opening on the bottom of the container.
8

Operation

!
WARNING! Fire hazard!
• When positioning the device, ensure the supply cord is not trapped or damaged.
• Do not locate multiple portable socket-outlets or portable power supplies at the
rear of the device.
I
NOTE
If there is a fault with the device (e.g. due to electrostatic discharging), press one of the
function buttons so that the device works normally again.
8.1 Before initial use
➤ Clean the device for reasons of hygiene (chapter "Cleaning and care" on page 10).
8.2 Cooling drinks
A
NOTICE!
The device does not switch off automatically when cooling. Because the device cools
drinks up to 22 °C below the ambient temperature, the drinks can freeze. When using
glass containers, ensure that they are not cooled for too long as otherwise the liquid
will freeze and the glass will break.
EN
Operation
9