Installing The Tv To The Wall - Sony 100Z9D Información Para La Instalación

Installing the TV to the Wall

Using the supplied Wall-Mount Bracket
To Customers
Sufficient expertise is required for installing this product. Be sure to subcontract the installation to
Sony dealers or licensed contractors and pay special attention to safety during the installation.
Sony is not liable for any damages or injury caused by mishandling or improper installation, or
installing any other than the specified product. Your Statutory Rights (if any) are not affected.
To Sony Dealers and Contractors
Sufficient expertise is required for installing this product. Be sure to read this instruction manual
thoroughly to do the installation work safely. Sony is not liable for any damages or injury caused
by mishandling or improper installation.
For product protection and safety reasons, Sony strongly recommends that
you use the Wall-Mount Bracket designed for your TV and the installation
should be performed by a Sony dealer or licensed contractor.
• Follows the instructions provided in this manual for installing the Wall-Mount Bracket. Sufficient
expertise is required for installing this product, especially to determine the strength of the wall for
withstanding the TV's weight.
• Be sure to use the screws supplied with the Wall-Mount Bracket when attaching the Wall-Mount
Bracket to the TV set.
The supplied screws are designed as indicated by illustration when measured from the attaching
surface of the Wall-Mount Bracket.
The diameter and length of the screws differ depending on the Wall-Mount Bracket model. Use of
screws other than those supplied may result in internal damage to the TV set or cause it to fall,
etc.
• Be sure to store the unused screws and Table-Top Stand in a safe place until you are ready to
attach the Table-Top Stand. Keep the screws away from small children.
NOTE
• Read the TV's Reference Guide for additional safety information.
• See page 2 (On Safety) before carrying out Wall-Mount Bracket installation.
• When attaching the Table-Top Stand again, be sure to fasten the screws (previously removed) to the original holes on the rear
of the TV.
4 (US)
10 mm - 16 mm
Screw (M8)
Wall-Mount Bracket
TV's Frame