SNOWJOE AQUAJOE AJ-SPXN-PRO Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Adjusting Water Flow and Spray Angle
1. During operation, use the water flow throttle
to adjust the water flow (Fig. 4).
Fig. 4
Increase
NOTE: The water flow rate can be adjusted
from as low as 2.8 GPM to as high as 3.3
GPM. Generally, with a higher water flow rate
there will be more water released from the
trigger gun. If the foam cannon is used, the
detergent in the bottle will be used up sooner
with a higher water flow setting.
2. When using the Quick-Connect spray nozzle,
the spray can be adjusted from 0° pencil
spray to 65° fan spray as needed by turning
the nozzle tip (Fig. 5).
Fig. 5
0° Pencil Spray
Working with Foam Cannon
For additional cleaning power, the unit comes
equipped with a foam cannon spray bottle.
1. Remove the foam cannon cap with detergent
suction tube from the detergent bottle. Fill
the detergent bottle with proper detergent
mixed with water as instructed on the
detergent label/manual (Fig. 6).
Decrease
Water flow Throttle
65° Fan Spray
Fig. 6
Foam cannon
cap with
suction tube
Detergent bottle
2. With the trigger released and the water
supply shut off, disconnect the Quick-
Connect spray nozzle by pulling back the
Quick-Connect collar (Fig. 7).
Fig. 7
Quick-Connect
collar
NOTE: Do not make change to nozzles when
the sprayer is on.
3. Snap the foam cannon onto the Quick-
Connect collar until it clicks into place
(Fig. 8).
Fig. 8
Trigger gun
Foam cannon
4. Turn on the water supply, and squeeze the
trigger. The detergent in the bottle will be
sprayed on the car.
4
Quick-Connect
Spray nozzle

Publicidad

Tabla de contenido
loading

Tabla de contenido