Automatic Mode - Overmax AD-06 Manual Del Usuario

OPTIMAL TEST TEMPERATURE
It is advisable to conduct tests and store the device at the room
temperature. Do not store the product if temperatures are extreme
and if conditions are highly humid (for example in the car in winter
or summer).
HOW TO TAKE A TEST
1.
Put the mouthpiece in a relevant inlet (upper left corner of
the device, marked in fig. 2).
Note – if a test is done without the mouthpiece, the results
may be inaccurate. It is advisable to replace the mouthpiece
before every measurement.
2.
Press and hold the on key for 2 seconds. After switching on,
the device will start heating sensors up. The entire procedure
takes up to 20 seconds (the counter will be showed on the
display, see: fig. 3).
Next choose one of two modes: automatic or manual.
Automatic mode – easier test mode. AD-06 monitors the user's
breath and then decides when to take the sample on its own (end
of air exhalation).
Manual mode – usually used when the automatic mode is
unfeasible.

AUTOMATIC MODE

A. When you can see „rdy" (abbreviated from „ready", see: fig.
4) and the device emits a short sound, take a deep breath
and blow into the mouthpiece which was previously inserted
into the device. Make sure you exhale long and evenly (not
too fast, at regular pace).
EN